Advertisement
CAPONORD 1200
1. Ground connection
2. Voltage 12V
Electrical specifications:
•
Side Stand Up: closed circuit (continu-
ity)
•
Side Stand Down: open circuit (infinite
resistance)
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
DIAGNOSTICS INSTRUMENT: STATUSES
Side stand sensor: up/down
•
indication on the diagnostics instrument always down: check the connector: if not OK, re-
store; if it is OK, disconnect the two terminals from the sensor and check continuity to ground
of PIN 1: if there is no continuity, restore the cable harness; if there is, replace the sensor.
•
Indication on the diagnostics instrument always up: disconnect the terminals from the sensor
and check if there is continuity between the two PINS, with stand down: if there is continuity,
replace the sensor; if the circuit is open, it means that the brown/green cable from sensor
PIN 2 to VEHICLE connector PIN 70 is short circuit to ground: restore the cable harness.
Bank angle sensor
(IF APPLICABLE)
Function
It tells the vehicle position to the control unit.
Operation / Operating principle
When the sensor is inverted, the circuit is closed
to ground: When the Marelli control unit detects
this ground connection, it does not enable start-up
or shuts off the engine.
Level in electrical circuit diagram:
Start-up enabling switches
Location:
•
on the vehicle: under the saddle, be-
hind the battery.
•
connector: next to the sensor (4-ways
connector).
Electrical system
ELE SYS - 159
Advertisement
