Table 9-1 Ip Phone Programming Options User Menu - NEC SL1100 Networking Manual

Issue 6.0
IP P
S 7
ECTION
This section describes how to access the programming interface for IP Phones. The
following describes how to access the User Menu.
1.
2.
DHCP S
S 8
ECTION
It is possible to use either an external DHCP server (e.g., Windows 2003 Server) or
the NEC SL1100 internal DHCP server. With IP Phones, either of these options
requires the DHCP server to be configured to supply the IP terminal options.
If using the internal DHCP server, enable the DHCP server. Refer to
Configuration 2 - Dynamic IP Addressing, One LAN on page
9 - 12
Programming - CPU:
10-12-01 : CPU Network Setup - IP Address
10-12-10 : CPU Network Setup - Subnet Mask
10-12-03 : CPU Network Setup - Default Gateway
10-12-09 : CPU Network Setup - VoIPDB IP Address
This assignment is for when the VoIP daughter board is
(
installed. )
Programming - VoIPDB DSP:
84-26-01 : VoIPDB Basic Setup - IP Address (Slot # - DSP)
Programming - IP Phones:
DHCP Mode:
IP Address:
Subnet Mask:
P
HONE ROGRAMMING
Using a DR700 telephone, press HOLD-Transfer-*-# buttons to enter program
mode. The IP User Menu is displayed.
On the IP User Menu, enter the user name and password for the IP Phone.
Settings are listed in Table 9-1 IP Phone Programming Options User

Table 9-1 IP Phone Programming Options User Menu

Programming Option
UserName
Password
C
ERVER ONFIGURATION
I
NTERFACE
ADMIN
6633222
NEC SL1100
0.0.0.0
255.255.255.0
198.168.1.254
192.168.1.20
192.168.1.21
Disabled
192.168.2.200
255.255.255.0
198.168.2.254
Menu.
Default
6.2 Example
9-9.
IP Multiline Station (SIP)