Conditions - NEC SL1100 Networking Manual

Issue 6.0
When assigning Diffserv values (for SL Net) go to program 84-10-01 and change the
type from Disabled to Diffserv. Then in program 84-10-07 assign the value for the
signaling (H.323) and voice (RTP/RTCP) packets. The next table shows an example
where the signaling packets are to be tagged as Class Selector 4 and the voice
packets are to be tagged as Expedited Forwarding.

6.1
13 - 8
After changes are made to Program 84-10 the system will need to be reset before the proper
values are inserted into the IP packets.

Conditions

CPU software 1500 (Version 1.50) or higher is required.

A maximum of five nodes and a total of 168 ports (below Version 3500)

or 256 ports (Version 3500 and above) total throughout the network.
InMail ports do not count against the 168 port (below Version 3500) or

256 port (Version 3500 and above) capacity.
This feature is only supported when networked with another SL1100; no

other system types are available.
Each system must be individually licensed for this feature with the

following license: SL-SYS-SL-NET-LIC.
Each system requires a VoIPDB.

Each site must have different extension numbers assigned. The same

extension number cannot exist at multiple sites.
Figure 13-3 Setup Example
NEC SL1100
SL Net