NEC SL1100 Networking Manual page 226

Issue 6.0
Program
Program Name
Number
IP System
Operation Setup –
SIP Peer to Peer
Mode
10-26-03
SIP Registrar/Proxy
Information Basic
10-33-02 Setup –
Authentication
Mode
SIP Registrar/Proxy
Information Basic
10-33-05
Setup NAT Mode
UPnP Setup –
UPnP Mode
10-37-01
Network Address –
Network Address
10-58-01
10 - 14
Description/
Comments
Enable or disable Peer-to-
Peer mode for SIP
phones with Version 4.0
or higher software. When
PRG 10-33-05 NAT mode
is set to 1 (Enable), P2P
mode for SIP phones
always set to Off
automatically regardless
of this program setting.
When connecting STD
SIP Terminal via NAT, this
option must be enabled to
prohibit illegal SIP phone
registration.
When system controls
remote SIP phone via
NAT router, set this
program to 1 = Enable.
Default Gateway (WAN),
PRG 10-12-07 can be set
automatically when this
program is set to 1 =
Enable. (Version 4.0
added)
If there are other
networks connected to
this system that are not to
be routed through NAPT
translations, then these
networks must be
identified in PRG 10-58.
Use this PRG to assign
the individual IP Address
(e.g. 192.168.1.100) or
assign the whole network
address (e.g.
192.168.1.0).
Assigned Data
0 = No (Disable)
1 = Yes (Enable)
default is 0
0 = No (Disable)
1 = Yes (Enable)
default is 0
0 = No (Disable)
1 = Yes (Enable)
default is 0
0 = No (Disable)
1 = Yes (Enable)
default is 0
Assign a valid IP Address or
assign a valid Network
Address.
default is 0.0.0.0
IP Single Line Telephone
NEC SL1100
1 2 3
X
X
X
X
X