Table of Contents
Advertisement
Trunk Telephone Menu Programming
Programming
194
To change the default setting for a telephone port, dial the 2 digit number that
corresponds to the telephone you want to change (01 to 14, or 01 to 16, as
Note
appropriate). For example, to change the setting for telephone Port 10, dial "1",
"0". Depending on the function number, dialling the port number will either toggle
its setting between two values or, where more than two values are available, will
cause that setting to flash. When the setting flashes, you are required to enter a
third digit, this being the new programming value (0 to 9, as appropriate). Port
numbers are shown in descending order, with Port 01 on the right-hand side of
the display.
Table 9-4: Trunk Telephone Menu Programming
Function
Function Name and
Number
Telephone Display
301
Delayed Ringing for
Trunk Line 1 for Day
Mode
P301 C01 RING DY
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
302
Delayed Ringing for
Trunk Line 2 for Day
Mode
P302 C02 RING DY
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
303
Delayed Ringing for
Trunk Line 3 for Day
Mode
P303 CO3 RING DY
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
304
Delayed Ringing for
Trunk Line 4 for Day
Mode
P304 CO4 RING DY
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
305
Delayed Ringing for
Trunk Line 5 for Day
Mode
P305 CO5 RING DY
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
306
Delayed Ringing for
Trunk Line 6 for Day
Mode
P306 CO6 RING DY
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Description
Used to assign the duration
of the delay between the
time the call is received and
the time the ringing tone is
heard. This option allows
you to delay ringing to
another telephone. This
assignment is for day mode.
Installation Manual, Chapter 9 – Telephone Programming
A6-506000-642-01(8508), Release 6.0, November 2003
Programming Values
0 = 0 sec.
3 = 30 sec.
1 = 8 sec.
4 = 60 sec.
2 = 16 sec.
5 = No Tone
Advertisement
Table of Contents
