NEC SL1100 Networking Manual page 74

Issue 6.0
6 - 12
prohibitive, and offers a significant improvement in speech quality over
older narrowband CODECs such as G.711, without an excessive
increase in implementation complexity.
G.726

G.726 is an ITU-T ADPCM speech CODEC standard covering voice
transmission at rates of 16, 24, 32, and 40kbit/s. It was introduced to
supersede both G.721, which covered ADPCM at 32kbit/s, and G.723,
which described ADPCM for 24 and 40kbit/s. G.726 also introduced a
new 16kbit/s rate. The four bit rates associated with G.726 are often
referred to by the bit size of a sample as 2-bits, 3-bits, 4-bits, and 5-bits
respectively.
G.729A

This ITU-T recommendation describes the algorithm for coding of
speech signals at 8kbps using CS-ACELP (conjugate-structure algebraic
code-excited linear prediction). This CODEC samples the analog signal
at 8000Hz and uses a frame size of 10ms. This CODEC has a MOS
score of 4.0.
G.729 is the most commonly used CODEC for NEC SL1100 VoIP
installations. This is due to the fact that it offers high compression (and
therefore low bandwidth) while maintaining good speech quality.
G.723

This ITU-T recommendation describes a very low bit-rate compression
algorithm. The standard describes two versions 5.3Kbps and 6.4Kbps.
NEC SL1100 uses the higher bit rate. This CODEC offers low bandwidth
speech transmission, but has a lower MOS score of 3.9. This CODEC is
not commonly used on the NEC SL1100, but is particularly suited to low
bandwidth WAN connections.
iLBC

The iLBC CODEC is an algorithm that compresses each basic frame
(20ms or 30ms) of 8000 Hz, 16-bit sampled input speech, into output
frames with rate of 400 bits for 30ms basic frame size and 304 bits for
20ms basic frame size. This CODEC is suitable for real-time
communications such as, telephony and video conferencing, streaming
audio, archival and messaging.
Packet Size:
Each CODEC has a set frame length. This is the time that the frame
encapsulates. For G.729 and G.711 the frame length is 10ms and for G.723
the frame length is 30ms. It is possible to configure the packet size in the NEC
SL1100 programming. To do this, we tell the NEC SL1100 how many frames
to encapsulate into each packet for transmission.
For example, the G.729 has a frame length of 10ms - the packet size is set to
3 (in Program 84-11-01). This gives a 10ms x 3 = 30ms packet.
NEC SL1100
Network Design Considerations