NEC SL1100 Networking Manual page 188

Issue 6.0
Program
Program Name
Number
DR700 Multiline
Basic Information
84-23-02
Setup – Subscribe
Expire Timer
DR700 Multiline
Basic Information
84-23-03
Setup – Session
Expire Timer
DR700 Multiline
Basic Information
84-23-04 Setup – Minimum
Session Expire
Timer
DR700 Multiline
Basic Information
84-23-05
Setup – Invite
Expire Timer
DR700 Multiline
Basic Information
84-23-06
Setup – Signal
Type of Service
DR700 Multiline
Basic Information
84-23-07
Setup – Error
Display Timer
DR700 Multiline
Basic Information
Setup – Digest
84-23-08
Authorization
Registration Expire
Timer
9 - 54
Description/Comments
At half the value of this timer the IP
terminal sends another Subscribe
message to the CPU.
At half the value of this timer the IP
terminal sends a re-invite
message.
Minimum time the CPU accepts a
session timer for a new call.
When INVITE message received
from SIP MLT does not contain
Expires header, the CPU uses this
value for timeout of outgoing call.
E.g. The SIP MLT hears RBT for
duration of this timer and then is
disconnected.
Used for updating the IP terminals
SIGNALING TOS values.
The time that an IP terminal holds
an error message in the display.
Setting 0 holds the error message
indefinitely.
When Digest Authentication mode
is ON, this value is available.
After receiving Initial INVITE
without authentication information,
CPU will send 401 message to the
SIP MLT, then waits for an INVITE
message with the authentication
message from SIP MLT within this
timer.
Additionally, after receiving Re-
REGISTER message for Keep
Alive purpose, the CPU sends a
401 message.
Assigned Data
Range: 60~65535
Sec.
Default is 3600
Range: 0~65535 Sec.
Default is 180
Range: 0~65535 Sec.
Default is 180
Range: 0~65535 Sec.
Default is 180
Range: 0x00 ~ 0xFF
Default is 00
Range: 0 ~ 65535 Sec.
Default is 0
Range: 0 ~
4294967295
Default is 0
IP Multiline Station (SIP)
NEC SL1100
1 2 3
X
X
X
X
X
X
X