Issue 6.0
9.1
1. Network
Settings
9 - 14
Layer 2 Priority Control
Layer 2 priority control can be enabled on an Ethernet switch, if it supports
VLAN tagging. This allows layer 2 prioritization.
Using a switch that supports 802.1p allows:
priority control
reduction of unnecessary packets (e.g., broadcast packets) and
provides circuitry by restricting a broadcast domain
9.1.1
Programming Layer 2 Priority Control
To program Layer 2 Priority Control for IP Phones VLAN/QoS:
1.
Press the Menu button on the IP Phone to enter the telephone
program mode.
This enters the IP program mode to select the settings for the
individual phone. The flashing item is the current selection.
1. DHCP Mode
:
:
:
:
6. Advanced Setting
2.
Press
OK, EXIT, SAVE
telephone to idle.
1. Speed & Duplex
2. VLAN Mode
3. VLAN ID
4. VLAN Priority
softkeys to save the entries and return the
IP Multiline Station (SIP)
NEC SL1100
Set VLAN Disable/Enable
Set same ID as 87-09-02
Set VLAN Priority