Siemens SINAMICS G120D Operating Instructions Manual page 337

Number Cause
A07457 Combination of input signals is not
permissible
F07458 Reference cam not found
F07459 No zero mark available
F07460 End of reference cam not found
A07461 Reference point not set
A07462 Selected traversing block number
does not exist
A07463 External block change not request-
ed in the traversing block
F07464 Traversing block is inconsistent
A07465 Traversing block does not have a
subsequent block
A07466 Traversing block number assigned
a multiple number of times
A07467 Traversing block has illegal task
parameters
A07468 Traversing block jump target does
not exist
Converter with control units CU250D-2
Operating Instructions, 04/2015, FW V4.7.3, A5E34261542B AB
Remedy
An illegal combination of input signals, which are simultaneously set was
detected, e.g.:
Jog 1 and jog 2 (p2589, p2590).
•
Jog 1 or jog 2 and direct setpoint input/MDI (p2589, p2590, p2647).
•
Jog 1 or jog 2 and start referencing (p2589, p2590, p2595).
•
Jog 1 or jog 2 and activate traversing task (p2589, p2590, p2631).
•
Direct setpoint input/MDI and start referencing (p2647, p2595).
•
Direct setpoint input/MDI and activate traversing task (p2647, p2631).
•
Start referencing and activate traversing task (p2595, p2631).
•
After starting the reference point approach, the axis has traversed
through the maximum permissible distance to search for the reference
cam without finding the reference cam. Remedy:
Check the "reference cam" binector input (BI: p2612).
•
Check the maximum permissible distance to the reference cam
•
(p2606).
If axis does not have a reference cam, then set p2607 to 0.
•
After leaving the reference cam, the axis traversed through the maximum
permissible distance between the reference cam and zero mark without
finding the zero mark. Remedy:
Check the encoder regarding the zero mark.
•
Check the maximum permissible distance between the reference cam
•
and zero mark (p2609).
Use an external encoder zero mark (p0494).
•
During the reference point approach, the axis, when approaching the zero
mark, has reached the end of the traversing range without identifying an
edge at the binector input "Reference cam" (BI: p2612). Remedy:
Check the "reference cam" binector input (BI: p2612).
•
Reference the system
Correct the traversing program.
Resolve the reason why the edge is missing at binector input (BI: p2632).
Check the traversing block and, if necessary, take into consideration any
alarms that are present.
Parameterize this traversing block with the step enabling condition
•
END.
Parameterize additional traversing blocks with a higher block number
•
and for the last block, parameterize the step enabling condition END.
Correct the traversing blocks.
Correct the task parameter in the traversing block.
Correct the traversing block.
•
Add the missing traversing block.
•
Alarms, faults and system messages
10.6 List of alarms and faults
337