Electric Heating Elements - Henny Penny LVE-102 Technical Manual

7-21. OIL LEVEL PROBES
(Continued)
7-22. ELECTRIC HEATING
ELEMENTS
Feb. 2011
9. Connect new temperature probe to connector and fasten
connector onto control panel.
10. Replace control panel and reconnect power to vat.
11. Fill vat by pressing and holding a
*FILTER* *MENU* shows in display. Then once
"1.AUTO FILTER" shows in the display, press
times until "5.FILL POT FROM DRN PAN" shows in
display. Press √ button; "FILL POT FROM DRN PAN"
"YES NO" displays. Press √ button again, display shows
"FILLING" "STOP?"and o il fills vat. Press √ button again,
display shows "FILL POT FROM DRN PAN" "YES NO".
When vat is full, press X twice to return to normal
operation.
1. Drain the oil from the vat by pressing and holding a
button until *FILTER* *MENU* shows in the display.
Then once "1.AUTO FILTER" shows in the display,
press 3 times until "4. DRAIN TO PAN" shows in the
display. Press √ button and "DRAIN TO PAN" "YES
NO" shows in the display. Press √ button again display
shows "DRAINING", and oil drains from vat. Once oil
has drained, display shows "VAT EMTY" "YES NO".
Visually check that vat is empty and press √ button, display
shows "DRAIN CLOSING..." and drain closes.
To avoid electrical shock or property damage, move
the power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
2. Using the lift tool, lift the hinged element from the vat and
position tool to support and keep the element raised up.
Avoid putting the lift tool at the center of the elements,
in the same area as the high limit bulb or damage to the
high limit could result.
3. Remove 2 screws, 2 high limit guards, and high limit
sensing bulb from heating elements as needed.
4. Remove remaining 4 or 6 screws, spreader straps, element
feet, and spreader bars from the heater being replaced.
7-26
Model LVE-102, 103, 104
button until
4