Cisco NCS 2006 Hardware Installation Manual page 330

To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of: 131°F (55°C). Statement 1047
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement
Warning
1018
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
Warning
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top
with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the unit in the rack. Statement 1006
Warning To prevent airflow restriction, allow clearance around the ventilation openings to be at least:1 inch
(25.4 mm) Statement 1076
Warning To comply with EN50121-4:2006 - Railway applications, Electromagnetic compatibility, a shielded
cable must be used to connect to the EMS port. This cable must be less than 30 meters in length and
not placed in the 3 meter boundary, as defined in EN50121-4:2006, Table 2, note 1. Statement 8010
Warning To comply with EN50121-4:2006 - Railway applications, Electromagnetic compatibility, DC power
cables must be less than 30 meter long. Statement 8011
The sections are:
• NTP-L48 Mounting Brackets on NCS 2015 Shelf for ANSI Rack Configuration, page 303
• NTP-L49 Mounting Brackets on NCS 2015 Shelf for ETSI Rack Configuration, page 307
Cisco NCS 2000 Series Hardware Installation Guide
302
Mounting the Brackets on the NCS 2015 Shelf