Configuration; Dlp-L3 Mounting The Reversible Brackets On The Ncs 2006 Shelf For Ansi Rack Configuration - Cisco NCS 2006 Hardware Installation Manual

Mounting the Brackets on NCS 2006 Shelf
Step 2 Loosen the screw and move it to the right position (towards the DC silk-screen text).
Step 3
Tighten the screw again to a torque value of 4 in-lb (0.45 N-m).
Step 4 Return to your originating procedure (NTP).
DLP-L3 Mounting the Reversible Brackets on the NCS 2006 Shelf for ANSI Rack

Configuration

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution Use only the fastening hardware provided with the NCS 2006 to prevent loosening, deterioration, and
electromechanical corrosion of the hardware and joined material.
Caution When mounting the NCS 2006 in a frame with a nonconductive coating (such as paint, lacquer, or enamel)
either use the thread-forming screws provided with the NCS 2006 ship kit, or remove the coating from
the threads to ensure electrical continuity.
In an ANSI rack, reversible mounting brackets (19-inch or 23-inch) are used to install the shelf. The
Note
mounting brackets can be installed in the front or the middle position of the chassis.

DLP-L3 Mounting the Reversible Brackets on the NCS 2006 Shelf for ANSI Rack Configuration

Cisco NCS 2000 Series Hardware Installation Guide
This task installs the reversible mounting brackets on
the NCS 2006 shelf for ANSI rack configuration.
• #2 Phillips Dynamometric screwdriver
• Medium slot-head screwdriver
• Small slot-head screwdriver
DLP-L62 Unpacking and Verifying the Shelf , on
page 20
DLP-L63 Inspecting the Shelf, on page 22
As needed
Onsite
None
169