Cisco NCS 2006 Hardware Installation Manual page 377

Connecting and Routing the Cables
Procedure
Step 1 Route the ECU cables on the ECU handle and fix the cables using tie-wrap. The following figure shows an
example of ECU cable routing. This allows you to close the front door.
Figure 200: ECU module Cable Routing in NCS 2015 DC Shelf
Step 2
Route the optical cables from the line cards through the cable module as shown in the figure above.
Stop. You have completed this procedure.
NTP-L55 Routing and Locking Cable and Fiber Modules
Cisco NCS 2000 Series Hardware Installation Guide
349