Dlp-L16 Replacing Ncs2006-Dc With Ncs2006-Dc20 Power Module; Tools/Equipment - Cisco NCS 2006 Hardware Installation Manual

Installing the Cisco NCS 2006 Door and Other Modules
The following figure shows a DC power module installed in Slot A and a power filler module installed in Slot
B.
Figure 172: Installing a Power Filler Module
Step 4 Return to your originating procedure (NTP).
Note

DLP-L16 Replacing NCS2006-DC With NCS2006-DC20 Power Module

Purpose

Tools/Equipment

Prerequisite Procedures
Required/As Needed
Onsite/Remote
When the NCS 2006 shelf is powered at –60 VDC (nominal), only the TNC, OPT-AMP-C,
OPT-AMP-17-C, OPT-EDFA-17, and OPT-EDFA-24 cards, and the NCS2006-ECU-60 can be
installed.
DLP-L16 Replacing NCS2006-DC With NCS2006-DC20 Power Module
This procedure replaces the NCS2006-DC with
NCS2006-DC20 power module.
#2 Phillips Dynamometric screwdriver
NTP-L5 Opening and Removing the Standard Door
of the NCS 2006 Shelf , on page 252
Required
Onsite
Cisco NCS 2000 Series Hardware Installation Guide
289