Connecting A Pc To The Cisco Isa 3000 For Configuration - Cisco ISA 3000 Connecting Instructions

Connecting a PC to the Cisco ISA 3000 For Configuration

• Ensure there is proper airflow around the device
Connecting a PC to the Cisco ISA 3000 For Configuration
The console connection of the ISA 3000 is not available for configuration. It is only used for troubleshooting
when directed by a support person. All configuration of the device is done through Cisco IoT Field Network
Director (FND) version 4.3 or greater.
There are two methods of connecting to the Cisco ISA 3000 in case of troubleshooting:
• Connect a PC to the console connector of the Cisco ISA 3000 and launch a console terminal to use the
• Connect the PC to the Cisco ISA 3000 management sub-network which will then receive an IP address
Step 1
Choose which console connection will be used. In the following figure, Item 1 is the RJ-45 console connector, and item
2 is the mini-USB connector.
Figure 1: Console Connection Ports
Connecting the Cisco ISA 3000
2
CLI. ASA has a full CLI set, however, FTD only supports a setup script plus a few commands.
through DHCP.
Connecting the Cisco ISA 3000