Connecting The Antenna Cable; Connecting The Ethernet Cables - Cisco AIR-BR350-A-K9 - Aironet 350 Wireless Bridge Hardware Installation Manual

Connecting the Antenna Cable

Connecting the Antenna Cable
The bridge provides two reverse TNC antenna connectors on the rear of the unit (see
diversity configurations with two antennas. When you are using a single antenna, you should connect
the antenna to the Right/Primary connector.
Figure 2-1
LE FT

Connecting the Ethernet Cables

Follow these steps to connect the straight-through Category 5 Ethernet cable and power supply to the
bridge:
Plug the RJ-45 Ethernet connector into the Ethernet port on the back of the bridge.
Step 1
Choose a power option for the bridge. The 350 series bridge receives power through the Ethernet
Step 2
cable.The 350 series bridge power options include:
•
•
•
Cisco Aironet 350 Series Bridge Hardware Installation Guide
2-6
SE RI AL PO
RT
RI GH T/P
RI MA RY
ON LIN E
PO W ER
ET HE RN
ET
Antenna
connectors
A switch with inline power, such as a Cisco Catalyst 3524-PWR-XL
An inline power patch panel, such as a Cisco Catalyst Inline Power Patch Panel
A Cisco Aironet power injector
Right/Primary
Chapter 2 Installation
Figure 2-1) for
OL-1412-01