Installing A Gpu Tray Into A Compute Node - Lenovo NeXtScale nx360 M4 Installation And Service Manual

2
Figure 21. Removal of a GPU tray
Step 4. Pull the GPU tray out of the compute node.
If you are instructed to return the GPU tray, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.

Installing a GPU tray into a compute node

Use this information to install a GPU tray in a NeXtScale nx360 M4 compute node.
Notes:
1. When you install the new GPU tray, you must have the latest firmware for both compute node and GPU
tray before you proceed. See "Updating the firmware" on page 21 for more information.
2. The GPU tray supports only 1300-watt power supply unit with high-line Vin (AC 200 volt to 240 volt).
Before you install the compute node in a chassis, read "Safety" on page v and "Installation guidelines"
on page 89.
To install the GPU tray to compute node, complete the following steps:
Step 1. Carefully lay the GPU tray on a flat, static-protective surface, orienting the GPU tray with the
release latch near your right hand side.
Step 2. Connect the cables that were disconnected from the GPU tray.
Step 3. Orient the GPU tray so that the posts on the inside of the GPU tray slide into the slots on the
compute node.
Note: Before you install the GPU tray, make sure that the air baffles and all components are
installed and seated correctly and that you have not left loose tools or parts inside the compute
node.
104
IBM NeXtScale nx360 M4 Installation and Service Guide
1