Managing Several Cutting Edges; Delete Tool - Siemens SINUMERIK 840D SL Operating Manual

13.5.4

Managing several cutting edges

In the case of tools with more than one cutting edge, a separate set of offset data is
assigned to each cutting edge. The number of possible cutting edges depends on the
controller configuration.
Tool cutting edges that are not required can be deleted.
Procedure
13.5.5

Delete tool

Tools that are no longer in use can be deleted from the tool list for a clearer overview.
Procedure
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
1. The tool list is opened.
2. Position the cursor on the tool for which you would like to store more
cutting edges.
3. Press the "Edges" softkey in the "Tool list".
4. Press the "New cutting edge" softkey.
A new data set is stored in the list.
The cutting edge number is incremented by one and the offset data is
assigned the values of the cutting edge on which the cursor is
positioned.
5. Enter the offset data for the 2nd cutting edge.
6. Repeat this process if you wish to create more tool edge offset data.
7. Position the cursor on the cutting edge that you want to delete and
press the "Delete cutting edge" softkey.
The data set is deleted from the list. The first tool cutting edge cannot
be deleted.
1. The tool list is opened.
2. Place the cursor on the tool that you would like to delete.
3. Press the "Delete tool" softkey.
A safety prompt is displayed.
Tool management
13.5 Tool list
545