Position Pattern Line (Holes1), Grid Or Frame (Cycle801) - Siemens SINUMERIK 840D SL Operating Manual

Programming technological functions (cycles)
8.1 Drilling
Parameter Description
(only for ShopMill) Axes: YB
Y0 Y coordinate of the 1st position (abs)
B0 B coordinate (angle) of the 1st position (abs)
Y1 ... Y8 Y coordinates of additional positions (abs or inc)
B1 ... B8 B coordinates (angle) of additional positions (abs or inc)
(only for ShopMill) Axes: XYA
X0 X coordinate of the 1st position (abs)
Y0 Y coordinate of the 1st position (abs)
A0 A coordinate (angle) of the 1st position (abs)
X1 ... X5 X coordinates of additional positions (abs or inc)
Y1 ... Y5 Y coordinates of additional positions (abs or inc)
A1 ... A5 A coordinates (angle) of additional positions (abs or inc)
(only for ShopMill) Axes: XYB
X0 X coordinate of the 1st position (abs)
Y0 Y coordinate of the 1st position (abs)
B0 B coordinate (angle) of the 1st position (abs)
X1 ... X5 X coordinates of additional positions (abs or inc)
Y1 ... Y5 Y coordinates of additional positions (abs or inc)
B1 ... B5 B coordinates (angle) of additional positions (abs or inc)
8.1.11

Position pattern line (HOLES1), grid or frame (CYCLE801)

Function
You can program the following pattern using the "Position pattern" cycle:
● Line (HOLES1)
● Grid (CYCLE801)
● Frame (CYCLE801)
312
In the "Line" selection option you can program any number of positions at equal distances
along a line.
You can use the "Grid" selection option to program any number of positions spaced at an
equal distance along one or several parallel lines.
If you want to program a rhombus-shaped grid, enter angle αX or αY.
You can use the "Frame" selection option to program any number of positions spaced at
an equal distance on a frame. The spacing may be different on both axes.
If you want to program a rhombus-shaped frame, enter angle αX or αY.
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
Unit
mm
Degrees
mm
mm
mm
mm
Degrees
mm
mm
Degrees
mm
mm
Degrees
mm
mm
Degrees
Milling