Tool management
13.5 Tool list
Tool type
585 Calibration tool
710 3D-probe milling
712 Mono-probe
713 L-probe
714 Star-type probe
You can use the configuration file to specify the data to be displayed for specific tool types in
the "Additional Data" window.
Procedure
542
Additional parameters
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Boom length (length)
Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Outer diameter (∅)
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1.
The tool list is opened.
2.
In the list, select an appropriate tool, e.g. an angle head cutter.
3.
Press the "Additional data" softkey.
The "Additional Data - ..." window opens.
The "Additional data" softkey is only active if a tool for which the
"Additional Data" window is configured is selected.
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
Milling