Siemens SINUMERIK 840D SL Operating Manual page 642

Easy Message (828D only)
18.4 Setting-up events
● Maintenance intervals
● Additional alarm numbers:
Requirement
● The user profile window is opened.
● You selected the event "Measuring cycle messages for tools", "Measuring cycle
Editing events
642
An SMS is sent if the service planner registers pending maintenance work.
Here, specify additional alarms where you should be notified if they occur.
You can enter individual alarms, several alarms or alarm number ranges.
Examples:
1234,400
1000-2000
100,200-300
messages for workpieces", "Sinumerik messages/alarms (errors when executing)",
"Machine faults" or "Maintenance intervals".
1. Activate the required check box and press the "Details" softkey.
The appropriate window opens (e.g. "Measuring cycle messages for
workpieces") and shows a list of the defined alarm numbers.
2. Select the corresponding entry and press the "Delete" softkey to
remove the alarm number from the list.
- OR -
Then press the "New" softkey if you wish to create a new entry.
The "Create new entry" window opens.
Enter the data and press the "OK" softkey to add the entry to the list.
Press the "Save" softkey to save the settings for the result.
3. Press the "Standard" softkey to return to the standard settings for the
events.
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
Milling