Panning A Graphical Representation; Rotating The Graphical Representation - Siemens SINUMERIK 840D SL Operating Manual

5.8.2

Panning a graphical representation

Precondition
The simulation or the simultaneous recording is started.
Procedure
5.8.3

Rotating the graphical representation

In the 3D view you can rotate the position of the workpiece to view it from all sides.
Precondition
Simulation has been started and the 3D view is selected.
Procedure
...
...
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
1. Press a cursor key if you wish to move the graphic up, down, left, or
right.
1. Press the "Details" softkey.
2. Press the "Rotate view" softkey.
2. Press the "Arrow right", "Arrow left", "Arrow up", "Arrow down", "Arrow
clockwise" and "Arrow counterclockwise" softkeys to change the
position of the workpiece.
- OR -
5.8 Changing and adapting a simulation graphic
Simulating machining
209