Displaying and inserting a G code command in the editor
See also
Additional functions in the input screens (Page 232)
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
2.
If you are in the "Start-up" operating area in the windows for the display
of the machine, setting and drive data, position the cursor on the
desired machine data or drive parameter and press the <HELP> or the
<F12> key.
The associated data description is displayed.
1.
A program is opened in the editor.
Position the cursor on the desired G code command and press the
<HELP> or the <F12> key.
The associated G code description is displayed.
2.
Press the "Display all G functions" softkey.
3.
With the aid of the search function, select, for example, the desired G
code command.
4.
Press the "Transfer to editor" softkey.
The selected G function is taken into the program at the cursor position.
5.
Press the "Exit help" softkey again to close the help.
Introduction
1.4 User interface
57