Renumber Program - Siemens SINUMERIK 840D SL Operating Manual

Machining the workpiece
4.10 Editing a program
Deleting program blocks
Note
The buffer memory contents are retained even after the editor is closed, enabling you to
paste the contents in another program, as well.
See also
Opening additional programs (Page 174)
4.10.4

Renumber program

You can modify the block numbering of programs opened in the editor at a later point in time.
Requirement
The program is opened in the editor.
Procedure
172
Use the "Cut" softkey to delete selected program blocks.
Note: When editing a program, you cannot copy or cut more than 1024
lines. While a program that is not on the NC is opened (progress display
less than 100%), you cannot copy or cut more than 10 lines or insert more
than 1024 characters.
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumber" softkey.
The "Renumbering" window appears.
3. Enter the values for the first block number and the increment to be used
for numbering.
4. Press the "OK" softkey.
The program is renumbered.
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
Milling