Siemens SINUMERIK 840D SL Operating Manual page 176

Hide thumbs Also See for SINUMERIK 840D SL:
Table of Contents

Advertisement

Machining the workpiece
4.10 Editing a program
Setting
Visible programs
Width of the program
with focus
Cut only after
selecting
Note
All entries that you make here are effective immediately.
Procedure
See also
Replacing program text (Page 170)
176
Meaning
1 - 10
Select how many programs can be displayed next to one another in the
editor.
Auto
Specifies that the number of programs entered in a job list or up to ten
selected programs will be displayed next to each other.
Here, you enter the width of the program that has the input focus, in the editor
as a percentage of the window width.
Yes: The cut of program sections is possible only when program lines have
been selected, i.e. the "Cut" softkey only then is enabled.
No: The "Cut" softkey is available by default.
1.
Select the "Program" operating area
You have activated the editor.
2.
Press the ">>" and "Settings" softkeys.
The "Settings" window appears.
3.
Make the desired changes here and press the "OK" softkey to confirm
your settings.
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
Milling

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840de slSinumerik 828d

Table of Contents