Sensor (Sfp Stapler Assembly Media In Stapler) Removal - Lexmark T652 Service Manual

Sensor (SFP stapler assembly media in stapler) removal

1
Remove the stapler unit assembly from the. Go to
on page 441.
2
Using a flat-blade screwdriver, release the tabs (A) securing the sensor.
3
Using needlenose pliers, carefully grip the sensor and pull it out and disconnect the harness.
Installation note: Using needlenose pliers, place the rear most tab in the sensor bracket first. Then push
on the rear face of the sensor until the other two tabs snap into place.
"SFP stapler assembly stapler unit assembly removal"
Repair information
448
A
4062