T650, T652, And T654 Operator Panel Door Assembly Removal - Lexmark T652 Service Manual

3
Release the two hooks (B).
B
4
Remove the operator panel latch assembly.

T650, T652, and T654 operator panel door assembly removal

Warning—Potential Damage: When replacing the operator panel assembly or the system card assembly,
only replace one component at a time. Replace the required component and perform a POR before replacing
another component. If this procedure is not followed, the printer will be rendered inoperable. Never replace
two or more components without a POR after installing each one or the printer will be rendered inoperable.
Never install and remove the components as a method of troubleshooting components. Once a component
has been installed in a machine, it cannot be used in another machine. It must be returned to the
manufacturer.
1
Remove the operator panel latch assembly. Go to
removal" on page 304.
2
Remove the three screws (A) securing the cover to the assembly.
3
Release the three hooks (B) securing the cover to the assembly.
A
"T650, T652, and T654 operator panel latch assembly
B A B A
Repair information
305
4062
B