5
Remove and unroute the cable to the deflector gate solenoid.
6
Disconnect the proper deflector gate solenoid harness from the controller card.
Installation note: To ease the cable unrouting, cut the appropriate cable.
5-bin mailbox transport solenoid removal
1
Remove the 5-bin mailbox left outer cover. Go to
2
Disconnect J15 at the controller card.
3
Remove the screw (A) securing the 5-bin mailbox transport solenoid to the left frame.
4
Remove the 5-bin mailbox transport solenoid.
Sensor (5-bin mailbox sensor deflector gate HP) removal
1
Remove the 5-bin left inner cover. Go to
2
Remove the following harnesses from the controller card: J14 A and B, J2, and J11.
A
"5-bin mailbox left inner cover removal" on page
Repair information
"5-bin mailbox left outer cover removal" on page
356
4062
344.
344.