Input Tray Tests - Lexmark T652 Service Manual

Duplex Feed 2
This test feeds a blank sheet of paper to the duplex paper stop position 2. This can be run using any of the
supported paper sizes.
1
From the Diagnostics menu, navigate to DUPLEX TESTS > Duplex Feed 2.
The power indicator blinks while the paper is feeding and Duplex Feed 2 Feeding... appears on the
display.
Note: Do not cancel this test.
When Duplex Feed 2 Clear Paper appears on the display, then remove the media from the duplex
2
unit.
3
From the control panel, press the Stop button to clear the message.

INPUT TRAY TESTS

Feed Tests (input tray)
This test feeds blank pages through the paper path. This runs using any supported paper or envelope sizes.
1
From the Diagnostics menu, navigate to INPUT TRAY TESTS > Feed Tests.
2
Select a paper source, and then select one of the following:
•
Single—This feeds a single page.
•
Continuous—This continuously feeds pages until the Stop button is pressed.
Sensor Test
This determines whether the input tray sensors are working correctly.
1
From the Diagnostics menu, navigate to INPUT TRAY TESTS > Sensor Test.
2
Select a paper source.
Note: Only installed paper sources are listed in the menu.
3
Select a sensor to test.
Sensors available for each paper source
Paper source
Tray 1
Tray 2
Tray 3
Tray 4
Multipurpose feeder
Envelope feeder
Tray empty sensor Paper low sensor Pass through sensor
Service menus
244
4062