No Fuse Check - Lexmark T652 Service Manual

Action
Step 5
Check the alignment assembly for proper adjustment. Go to
"Alignment assembly adjustment" on page
replace the aligner assembly. Go to
removal" on page 271.
Does the problem remain?
Step 6
Remove the fuser unit assembly, and then check the heat roll and
pressure roll for contamination or cracks. If necessary, replace the
fuser unit assembly. Go to
page 331.
CAUTION—HOT SURFACE: Allow the fuser unit assembly
to cool down.
Does the problem remain?

No fuse check

Leading edge
ABC
DEF
Action
Step 1
Check the media type and printer media settings, and adjust them
if necessary.
Does the problem remain?
Step 2
Check the fuser unit assembly for proper installation, and reinstall
the assembly if necessary.
Does the problem remain?
Step 3
Check the media condition. If necessary, load new, dry,
recommended media, and then reprint the defective image.
Does the problem remain?
268. If necessary,
"Alignment assembly
"Fuser unit assembly removal" on
Trailing edge
Diagnostic information
Yes
Go to step 6.
Contact the next
level of support.
Yes
Go to step 2.
Go to step 3.
Go to step 4.
54
4062
No
Problem is solved.
Problem is solved.
No
Problem is solved.
Problem is solved.
Problem is solved.