Printer Setup - Lexmark T652 Service Manual

Disk Test/Clean
Note: This is applicable only to model T656.
Warning—Potential Damage: This test destroys all data and should not be attempted on a good disk.
1
From the Diagnostics menu, navigate to DEVICE TESTS > Disk Test/Clean.
2
Touch Yes to continue.
Note: This test cannot be canceled, and this may run approximately 1½ hours depending on the disk size.
A progress bar appears on the display.
3
After the test is completed, check the message on the display to determine whether the test passed or
failed. If the test fails, then the disk is unusable.

PRINTER SETUP

Defaults
Warning—Potential Damage: Data may be lost.
This setting is used by the printer to determine whether U.S. or international factory default values should be
used. The following are among the printer settings affected:
•
Paper size
•
Envelope size
•
PCL symbol set
•
Code pages
•
Units of measure
1
From the Diagnostics menu, navigate to PRINTER SETUP > Defaults.
2
Select US or Non‑US.
3
Depending on your printer model, touch Submit or press the Select button to apply the changes.
Printed Page Count
The value of this setting gauges the amount of usage on the printer. The value will equal the values of the
Picked Sides meter. After all print tests have been completed, the value will reset to zero.
Note: The value of the setting cannot be changed manually.
To view the page count, from the Diagnostics menu, select PRINTER SETUP > Printed Page Count.
Permanent Page Count
Note: The Permanent Page Count value cannot be reset.
The value of this setting indicates the total amount of pages that have been printed. After all print tests have
been completed, the value will reset to zero.
1
From the Diagnostics menu, select PRINTER SETUP.
2
Depending on your printer model, select Perm Setup Page or Permanent Setup Page.
Service menus
250
4062