Lexmark T652 Service Manual page 251

Serial Number
Note: The value of the setting can only be viewed.
1
From the Diagnostics menu, navigate to PRINTER SETUP > Serial Number.
2
Depending on your printer model, touch Back or press the Back button to return to PRINTER SETUP.
Engine Setting [x]
Warning—Potential Damage: Do not change these settings unless requested to do so by your next level of
support.
These settings are used by Engine code ECs to fix field problems. [x] represents any value from 1 to 16.
Model Name
The model name can only be viewed and cannot be changed.
Configuration ID
There are two configuration IDs that are used to communicate information about certain areas of the printer
that cannot be determined using hardware sensors. The IDs are originally set at the factory when the printer is
manufactured. However, you may need to reset Configuration ID 1 or Configuration ID 2 whenever you replace
the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A through F.
When the printer detects a Configuration ID that is not defined or invalid:
•
The default standard model configuration ID is used instead.
•
The configuration ID becomes the only function available in DIAGNOSTICS.
Check Config ID appears on the display except when the menu is in DIAGNOSTICS.
•
1
From the Diagnostics menu, navigate to PRINTER SETUP > Configuration ID.
Note: Submitting Selection and the value for Configuration ID 1 appear on the display
2
Enter configuration ID 1.
•
Use the left or right arrow button to select a digit or character. Wait until the digit or character is
underlined.
•
Use the up or down arrow button to change a digit or character.
Notes:
–
When the last digit or character is changed, press the select button to validate Configuration ID 1.
If the process is successful, then Submitting Selection and the value for configuration ID 2
–
appear on the display.
3
Enter configuration ID 2.
4
Depending on your printer model, touch Submit or press the Select button to apply the changes.
Note: The process is successful if Submitting Selection or a check mark, depending on your
printer model, appears on the display.
5
Restart the printer.
Service menus
251
4062