5022-xxx
Operator panel assembly removal
Warning: When replacing any one of the following components:
•
Operator panel assembly
•
System card
•
Smart chip card
Only replace one component at a time. Replace the required component and perform a POR before
replacing a second component listed above. If this procedure is not followed the printer will be rendered
inoperable.
1.
Remove outer bezel. See
2.
Remove screw (A).
3.
Disengage upper locking tabs (B).
4.
Remove screw (C) and ground cable.
5.
Disconnect cable (D).
Note: When reinstalling, ensure ground cable is oriented as shown in the illustration or the operator panel will
not mount.
4-22
Service Manual
"Operator panel outer bezel removal" on page
4-21.