Replacement Of A Handbrake Release Trigger - CITROËN ID 19 Repair Manual

ID 19
OPERATION No. ID 454- 1
: Work on the mechanical brake control Op. ID 454-l
305
20
Fit the upper panel of the instrument board and tighten the fixing screw (cup washer under the head).
21
22
Fit the glove compartment and tighten the fixing screws.
Fit the central panel of the instrument board and tighten the fixing screws (rubber buffer of the glove compartment
under the upper fixing screw).
23
Fit the left-ha?d side protection panel.
Fit the left-hand front wing. Fit the spare wheel . . . . . . . . . . . . . . . . . . . . . . .
REPLACEMENT OF A HANDBRAKE RELEASE TRIGGER
Removal (see Pl. 109).
24
25
Remove the handbrake handle (see this operation, paragraphs 1 and following).
Unscrew the locknut (12) and remove the adjusting screw (13) of the release control rod ,11) . . . . . . . . . . . . . . . . . . .
26 Using a 4.5 mm drill break the rivetted joint (at
"a") of the fulcrum pin (15) of the release trigger (10). Remove the
fulcrum pin (15).
27
Disconnect the spring (16) from the rod (11). Withdraw the rod from the guide hole on the trigger and remove the
trigger.
28
29
30
31
32
Refitting (see Pl. 109).
Hold the release control rod (11)
f rom the front and place the release trigger (10)
in position on the brake handle.
Fit the trigger fulcrum pin (15)
( make
with a 90' punch.
sure that it is correctly positioned). Rivet the fulcrum pin on the brake handle
Insert the release control rod (11) in the guide hole in the trigger.
Connect the spring (16) to the rod (II).
Fit the release control rod adjusting screw (13) together with its locknut (12) on the trigger (10).
Fit the handbrake handle (see paragraphs 10 and following, this operation).
TOOLS
8-12-14 mm box
spanners
7 mm box spanner