CITROËN ID 19 Repair Manual page 220

214 OPERATION No. ID 4 13- 1 : Work 012 the front
axle
ID 19
9
10
11
15
22
23
24
31
34
38
Particular Points.
Replacement of a pivot steering lever.
Removal.
Mark the position of the adjusting washers on the lever.
Assembly.
Determine the thickness of the adjusting washers to befitted with the
new
lever (see Op. ID. 413-0, paragraphs 5 and 6).
Tighten the levei.,fixing screws to 36 ftlbs.
(5 m.kg.). (D o not exceed this tightening torsion, use a torsion spanner 2471-T).
Check the alignment and the steering lock. Check the functioning of the other ball joints,
(steering
levers, lower relay levers).
Replacement of an upper pivot ball joint.
-- --__
The.fitting of the lozcer cup by means of a hammer or a press is detrimental to the pivot, use the fixture 1857-T (see Pl. 63, fig. 2).
Determine the thickness of the adjusting washers of the ball joint (see Op. ID. 413-O paragraphs I to 4).
Tighten the lever fixing screws to 36 ft.lbs. (5 mkg.).
(D o not exceed this tightening
torsion, use a torsion spanner 2471-T).
Replacement of a lower pivot ball joint.
Determine the thickness of the flange adjusting washers (feeler gauge). The clearance of the ball joint should be 0. I mm. after tightenang the
flange to 36 ftlbs. (5 m.kg.). (D o not exceed this tightening torsion, use a torsion spanner 2471-T).
Replacement of a wheel locking cone.
It is
necessary
to remove the pivot and driveshaft assembly and disconnect the driveshaft from the pivot in order to carry out this operation
(see Op. ID. 372-l).
Replacement of a wheel positioning dowel.
This operation requires the removal of the wheel.
TOOLS
REPLACEMENT OF A PIVOT SEAL
Removal (see Pl. 62).
Remove the pivot and driveshaft assembly (see Op. ID 372-1, paragraphs 1 to 4).
Place the pivot and driveshaft assembly in a vice (vice support 1922-T, see Pl. 66, fig. 1).
Remove the seal (12) using a screwdriver
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Vice support 1922-T