CITROËN ID 19 Repair Manual page 314

308
OPERATION No. ID 454-3
: Overhauling u hand brake control
ID 19
REMOVAL (see Pl. 109).
Remove the hollow fulcrum pin (9) from the lever.
To remove the release trigger (10) :
a) With a 4.5 mm drill, remove the rivet joint of the pin (15) at "a" (see fig. 4). Remove the pin.
b) Unlock the locknut (12) and remove the screw (13) and the locknut.
c) Tilt the lock (18) upwards and remove the release trigger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To remove the lock (18) :
. . . . . . . . . . . . . . . . .
a) Remove the split pin from the lock fulcrum pin (19). R emove the washer (20) and the pin
(19).
Do not lose the
distance washer (21).
b) Remove the release rod and lock assembly. Remove the rod (11) from the lock (18).
Remove the return spring (16) from the lock (18).
ASSEMBLY (see Pl. 109).
Put the spring (16) in position in the control lever.
Fit the release trigger (10) and fit the pin (15) without rivetting it.
To fit the lock (18) :
a) Engage the release rod (11) in the lock (18)
and position this assembly in the control lever, with the end of the rod
engaged in the bore "b" in the release trigger (10).
b) Fit the pin (19), the distance washer (21) and the washer (20) and lock the pin (19) with a split pin.
c) Attach the spring (16) to the release rod (11).
Hold the release trigger (10) locked against the lever control handle and rivet the release trigger fulcrum pin (15)
(at 'la", see fig. 4).
Fit the hollow pin
(9)
in the lever bearing (22) after previously oiling.
TOOLS
7 mm box spanner