CITROËN ID 19 Repair Manual page 58

56
18
Fit the cylinder head, fitted with the inlet rockershaft (make sure that the two locating dowels are on the cylinder block.
Fit the push rods (slightly raise the rockershaft). Fit the exhaust rockershafts.
Tighten the cylinder head fixing screws: 1st tightening 21.75 ft. lbs. (3 mkg), 2nd tightening 43.5 ft. Ibs. (6 m.kg) (do not exceed the tightening
torsion and observe the order of tightening indicated on P1.7).
Adjust the valve clearances to: inlet
0.008" (0.20 mm), exhaust
0.010" (0.25 mm) (see Op.ID 122-O).
Drain the coqling system. Retain the water,"which contains anti-freeze.
Remove the air filter and pipe assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disconnect the leads from the sparking plugs.
Disconnect the choke control and the accelerator control from the carburettor.
Disconnect the fuel inlet pipe and the vacuum pipe from the carburettor.
Remove the carburettor (spanner 1645-T, see Pl. 16, fig. 3) . . . . . . . . . . . . . . . . . . . . . . . . .
I
Disconnect the intake and delivery hoses from the water pump.
..,......,.......
12-17 mm box spanners
. . . . . . . ..*.......
Remove the radiator tie-bar
.............................................................................
Remove the fan ........................................................................................
Remove the dynamo tie-rod and release the belt
............................................................
9
Disconnect the retaining bracket for the front brake coq?ection pipe from the water pump
. . . . . . . . . . . . . . . . . . . . .
10
Disconnect the lubrication tube from the cylinder head ': . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
11 Disconnect the feed hose for the heating and demister radiator from the pipe on the cylinder head.
OPERATION No. ID 11
Z-
1
: Replacement of a cylinder head or a cylinder gasket
ID 19
.
PARTICULAR POINTS
Removal
Disengage the push rods by lifting the inlet rockershaft sl&ht[y. Remove the cylinder head jilted with the inlet rockershaft.
Fit the cylinder head gasket, ,with the crimping
towards the cylinder barrels. Old
type gaskets must be smeared with boiled linseed oil, Neza gaskets
(varnished) arefitted dry.
As s embly
REMOVAL (see Pl. 1 and 3).
-, vs.=.. :
TOOLS
8 mm box spanner
Spanner 1645 -T
8-12 mm box spanners
12 mm box spanner
12-14 mm spanners
and box spanners
12 mm box spanner
12 mm box spanner