CITROËN ID 19 Repair Manual page 170

164 OPERATION
NO. ID 330-4 : Replacement of a dz~erential shaft,
brake
disc or diflerential shaft bearing.
ID 1
1 Remove the spare wheel, the spare wheel support, the front wings,
the air deflector panel and the brake cooling duct.
Remove the battery and the battery tray. Remove the battery bracket and withdraw it towards the front .
2
Remove the steering assembly (see Op.ID. 100-1, paragraph 9)
3
Remove the radiator and the brake unit (see Op.ID. 451-1).
4
Jack up the front of the car (jacking bracket 2505-T, see PI. 111).
Remove the front wheels.
Remove the drive shaft dust shields from the sidemembers.
Remove the clip securing the drive shaft dust shield and remove the dust shield from the flexible coupling (Bibax) . .
5
Remove the front axle arms from the pivot (extractor and pressure pad 1864-T, see Pl. 64, fig. 3). Remove the rubber
cups and the nylon cups from the pivot sockets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6
Disconnect the steering rod from the pivot lever (extractor 1964-T and pressure pad 1968-T, see PI. 64. fig. 2).
Remove the rubber cup and the nyloncup from the lever socket
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
7
Remove the closing panels under the brake discs.
Drainthegearbox . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8
Turnupthelocking pieces and remove the fixing screws on the front crossmember of the gearbox support.
Remove the screws securing the supportonthe gearbox . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
9
10
11
12
Pull back the support arm towards the brake disc and remove the four gearbox driving $ate bearing fixing screws . .
Remove the flexible coupling (Bibax), the brake disc and the support arm and bearing assembly from beneath the
vehicle
IMPORTANT NOTE - Do not mislay the adjusting washer (4) and the differential bearing distance piece (5) (see P1.45)
NOTE - If necessary, disconnect the Bibax from the brake disc before rem
Disconnect the flexible coupling (Bibax) from the brake disc.
Strip the bearing of the gearbox driving plate (see Op.ID. 330-3, paragraph 1
oving the assembly on the right hand side.
8a).
REMOVAL
TOOLS
8-
,12-14 mm box spanners
Jacking bracket 2505-T
8 mm box spanner
26 mm box spanner
Extractor and pressure
pad 1864-T
21 mm box spanner
Extractor 1964-T
Pressure pad 1968-T
21 mm box spanner
14 mm spanner and ring
or spanner 2126-VA
14 mm box spanner
12 mm spanner