CITROËN ID 19 Repair Manual page 125

ID
19 OPERATION No. ID
2 3 1 - 0 : AZignment of puhys
Op.ID 231-O
123
Example 1 - The clearance "d" measured at "i" = 0.3 mm.
The thickness of the adjusting washers will have
to be reduced by:
(0.15 x 5) + (0.225 x4) = 0.75 t 0.90 = 1.65 mm.
2nd. case:
When the rod bears on "i". If the clearance "d" measured at "h" exceeds 0.225 f 0.05 mm, the thickness
of the adjusting washers of the pulley will have to be increased by 4 times the difference between the
measured clearance and 0.225 mm.
d
Example 2 - Clearance "d" measured at "h" = 0.40 mm.
The thickness of the pulley adjusting washers
will have to be increased by: (0.40 - 0.225) x 4 = 0.70 mm.
3rd. case:
If the clearance "d" measured at "h" is less than : 0.225
* 0.05 mm, the thickness of the adjusting washers
will have to be reduced by 4 times the difference between 0.225 mm and the clearance measured.
Example 3 - Clearance "d" measured at "h" = 0.02 mm.
The thickness of the pulley adjusting washers
will have to be reduced by:
(0.225 - 0.020) x4
= 1 mm.
.
Remove the pulley. Remove the adjusting washer or washers,
measure the thickness and select a washer of
suitable thickness from among those sold by our Spare Parts Department.
Fit the adjusting washer or washers in accordance with the above calculations and fit the pulley.
Check the alignment (see paragraph 2).
Remove the gauge pin bracket (B).
TOOLS