CITROËN ID 19 Repair Manual page 327

ID 19 OPERATION No. ID 533-l
: Replacement of a starter.motor
Op. ID 533-l
321
1 Release the pressure.
2
3
4
Remove the sphere from the right-hand suspension cylinder. Seal the cylinder (cap D 434-70, see Pl. 89).
Seal the sphere (cap D 433-82, see Pl. 89).
Remove the exhaust manifold shield.
It may be necessary to bend this shield in order to move it towards the front
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5
6
Disconnectthe starter feed cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
14 mm box spanner
To remove the starter motor: unlock the locknut and unscrew the pointed screw a few turns from the housing.
Unscrew a few turns the pointed reaction screws situated under the clutch bellhousing. Move the starter motor
from its housing and disengage from the rear. If necessary turn the body of the starter to simplify this operation.
REFITTING
7
Engage the Bendix housing of the starter motor in its housing in the crankcase. If necessary turn the body of the
starter motor to simplify this operation: a slight push should be sufficient to pass the starter motor between the
manifold and the body.
8 Tighten the pointed screw and its locknut.
Do not tighten excessively as this will only distort the Bendix housing . . . . . .
9
10
11
12
13
14
Tighten the pointed reaction screws. Lock the locknut . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect the starter motor cable: insert a serrated washer under the terminal and tighten the nut.. . . . . . . . . . . . . . . . . . .
12-14 mm box spanners
Refit the exhaust manifold shield. It may be necessary to slightly bend this shield in order to put it in position.. . . . . . . 12 mm box spanner
Fit the fixing screws, insert a plain and spring washer under the heads.
Fit the sphere (replace the seal plate after each removal).
Start the engine, put the systems under pressure, check for leakage between the sphere and the suspension cylinder.
REMOVAL
TOOLS
12 mm box spanner
14-17 mm tee spanners
14-17 mm tee spanners
12 mm spanner