CITROËN ID 19 Repair Manual page 270

264 OPERATION No. ID 442
-
1
: Replacement
of a steering
assembly
ID 19
9 Rotate the steering pinion (11) until the outer bush (12) on the left hand steering arm rod flexible bush is at a distance
of "d" = 275 mm from the centreline of the rack pressure pad cap (see P1.93).
10
NOTE - A difference of more than 1 mm will cause excessive play of the steering wheel arm.
Set the arm of the steering wheel so that it is 30° below the horizontal, on the left hand side.
Connect the flexible coupling (10) to the steering pinion (11).
Compress the spring (3) (spring compressor 1991-T, see P1.91, fig.1). When the spring is fully compressed tighten
the screw (4) of the collar (5) ( p
s anner 1994-T, seeP1.91, fig.3) . . . . . . .._................................
11 Turn the steering wheel to make sure that the steering assembly and the steering wheel are correctly aligned
. . . . .
12
13
14
15
. . .
16
Tighten the bearing cap fixing screws . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Make sure that there is no play by alternately pulling and pushing on the steering wheel.
Fit the instrument panel cover.
Fit the battery tray. Fit and connect the battery. Lower the car to the ground . . . . -. .
With the car at its normal height ("normal" position):
4
Adjust the track (see Op.ID 440-o).
b) Adjust the steering lock (see Op.ID 440-o).
Fit the left hand front wing and the spare wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
........
........
........
. . . . .
..*.. . .
. .
. . . . . . . . .
. . .
. . .
, .
. . .
. . .
. . .
TOOLS
12 mm box spanner
Spring compressor 1991-T
Spanner 1994-T
12 mm box spanner
12 mm box spanner
12-14 mm spanners
and box spanners