CITROËN ID 19 Repair Manual page 171

ID 19
13
14
15.
16
17
18
19
20
21
22
23
24
25
Op.ID 330-4
TOOLS
OPERATION No. ID 330-4: Replacement of a differential shaft, brake disc or dijferential shaft bearing
165
REFITTING (see Pl. 45)
Assemble the gearbox driving plate bearing (see Op.ID. 330-3, paragraphs 25 and 26~).
Place the distance piece (4) and the differential bearing adjusting washer (5) in position.
Place the flexible coupling, brake disc,
directed downwards).
support arm and gearbox driving plate bearing in position (the outlet pipe
Insert the paper gasket, affixing it to the bearing with grease.
Tighten the 4 fixing screws
(3) of the gearbox drive plate bearing . . . . . !. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm spanner
Insert, without tightening, the screws (1) securing the support arm on the gearbox (plain washers under the screw
heads).
Tighten the fixing screws securing the support arm on the front crossmember.
Turn down the locking pieces. 14 mm box spanner
Tighten the fixing screws securing the support arm to the gearbox . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . , . 14 mm spanner and ring
or spanner 2126-V-A
Connect the flexible coupling to the brake disc if these parts were disconnected (right hand side).
Place the brake disc locating screws in their bores on the flexible coupling.
Tighten the fixing screws . . . . . . . _ . .
12 mm box spanner
Place the drive in position in the gearbox drive plate slide.
Carefully remove the grease from the cones of the front axle arms and from the pivot sockets.
Connect the front
axle arms to the pivot sockets. Insert the nylon cups and the rubber cups. Tighten the nuts and lock with split
pins................................................................................................... 26 mm box spanner
Remove the grease from the cones of the steering rod and from the socket on the pivot lever.
Connect the steering
rod to the pivot lever. Insert the nylon cup and the rubber clip. Tighten the nut and lock with a split pin . . . . . . . . 2 1 mm box spanner
Place the drive shaft dust shield on the flexible coupling.
Fit a Ligarex clip (pliers 2483-T, see P1.17, fig.2).
Fit the drive shaft dust shields on the sidemembers. Tighten the screws (plain and spring washers under the heads). .
Pliers 2483-T
Fit the brake unit and the radiator (see Op.ID.451-1).
8 mm box spanner
Fit the steering assembly (see Op.ID. 100~1, paragraph 42).
Place the battery bracket in position. Tighten the fixing screws (plain and spring washers under heads). Insert the
distance piece between the battery bracket and the front engine support crossmember.
Fit the battery tray. Fit and connect the battery
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..I
12 mm spanner and
box s panne r