Danfoss vlt AQUA Instruction Manual page 46

5 Electrical installation
5.1.25 Control Terminals
Drawing reference numbers:
1. 10-pole plug, digital I/O.
2. 3-pole plug, RS-485 bus.
3. 6-pole, analog I/O.
4. USB connection.
5
5.1.26 Control Cable Clamp
1. Use a clamp from the accessory bag to connect the shield to the
adjustable frequency drive decoupling plate for control cables.
Grounding of Shielded/Armored Control Cables
See the section entitled
for the correct termination of control cables.
5-24
Figure 5.43: Control terminals (all enclosures)
Figure 5.44: Control cable clamp.
®
MG.20.M5.22 - VLT is a registered Danfoss trademark
®
VLT AQUA Drive
Instruction Manual