Danfoss vlt AQUA Instruction Manual page 108

8 How to program the adjustable frequency
drive
22-33 Low Speed [Hz]
Range:
0 Hz* [0.0 - par. 22-37 Hz]
22-34 Low Speed Power [kW]
Range:
0 kW* [0.00 - 0.00 kW]
22-35 Low Speed Power [HP]
Range:
0 hp* [0.00 - 0.00 hp]
22-36 High Speed [RPM]
Range:
8
0 RPM* [0 - par. 4-13 RPM]
22-37 High Speed [Hz]
Range:
0.0 Hz* [0.0 - par. 4-14 Hz]
22-38 High Speed Power [kW]
Range:
0 kW* [0.00 - 0.00 kW]
22-39 High Speed Power [HP]
Range:
0 hp* [0.00 - 0.00 hp]
22-40 Minimum Run Time
Range:
10 s* [0 - 600 s]
8-38
Function:
To be used if par. 0-02 Motor Speed Unit
Set used speed to the 50% level.
The function is used for storing values needed to tune No-flow Detection.
Function:
To be used if par. 0-03 Regional Settings
North America selected).
Set power consumption to 50% speed level.
This function is used for storing values needed to tune No-flow Detection.
Function:
To be used if par. 0-03 Regional Settings
International selected).
Set power consumption to 50% speed level.
This function is used for storing values needed to tune No-flow Detection.
Function:
To be used if par. 0-02 Motor Speed Unit
Set used speed for the 85% level.
The function is used for storing values needed to tune No-flow Detection.
Function:
To be used if par. 0-02 Motor Speed Unit
Set used speed for the 85% level.
The function is used for storing values needed to tune No-flow Detection.
Function:
To be used if par. 0-03 Regional Settings
North America selected).
Set power consumption to 85% speed level.
This function is used for storing values needed to tune No-flow Detection.
Function:
Regional Settings
To be used if par. 0-03
International selected).
Set power consumption to 85% speed level.
This function is used for storing values needed to tune No-flow Detection.
Function:
Set the desired minimum running time for the motor after a start command (digital input or bus)
before entering sleep mode.
®
MG.20.M5.22 - VLT is a registered Danfoss trademark
has been set for Hz (parameter not visible if RPM selected).
has been set for International (parameter not visible if
has been set for North America (parameter not visible if
has been set for RPM (parameter not visible if Hz selected).
has been set for Hz (parameter not visible if RPM selected).
has been set for International (parameter not visible if
has been set for North America (parameter not visible if
®
VLT AQUA Drive
Instruction Manual