4�3�- Display; 4�3�1� Cos; Pf (Power Factor) Bar - Circutor CVM-C10 Instruction Manual

4.3.- DISPLAY
The device has a backlit LCD display showing all the parameters listed in
The display is divided into four areas (
 The area with data per phase displays the instantaneous, maximum and minimum
values of each phase being measured or calculated by the device.
The total data area displays the totals of the values being measured or calculated by
the device.
Analogue bar, displays the % of the current power of the installation.
Cos
4�3�1� cos
This bar displays the value of the installation's cos
The parameter that will be displayed is selected on the programming menu. (
the Cos φ - PF bar on the display"
Note : This bar will not be displayed in the IEC and IEEE measurement conventions.
34
, displays the value of the system's Cos
φ - PF Bar
φ - PF (POWeR fACTOR) BAR
):
figure 22
figure 22: CVM-C10 Display areas
figure 23: Cos φ - PF Bar
or power factor in real time.
φ
)
.
Table 3
or power factor in real time.
φ
"4.9.14. Selecting
Instruction Manual
CVM-C10