Kyocera TASKalfa 3050ci Service Manual page 212

Item No.
U464 Setting: [Leaving Time]
1. Change the setting value using the +/- keys or numeric keys.
Display
Time(min)
2. Press the start key. The value is set.
Setting: [Driving Time]
1. Change the setting value using the +/- keys.
Display
Time(sec)
2. Press the start key. The value is set.
Setting: [Timing]
1. Change the setting value using the +/- keys.
Display
Time(sec)
2. Press the start key. The value is set.
Setting: [Target Value]
1. Select the item.
2. Change the setting value using the +/- keys or numeric keys.
Display
Thickness(C)
Thickness(M)
Thickness(Y)
Thickness(K)
Gamma(C)
Gamma(M)
Gamma(Y)
Gamma(K)
3. Press the start key. The value is set.
Description
Description
Setting the standard time of sleep mode
Description
Setting the drive standard time
Description
Setting the drive standard time of con-
tinuous print
Description
Toner thick layer calibration (cyan)
Toner thick layer calibration (magenta)
Toner thick layer calibration (yellow)
Bias for addition in toner thick layer
calibration (black)
Light amount calibration (cyan)
Light amount calibration (magenta)
Light amount calibration (yellow)
Light amount calibration (black)
1-3-170
2LK/2LN/2LM/2LC
Initial
Setting range
setting
0 to 480 (min) 60
Initial
Setting range
setting
300 to 3000 (s) 600
Initial
Setting range
setting
300 to 3600 (s) 1800
Setting Initial
range setting
0 to 1000 500
0 to 1000 500
0 to 1000 500
-100 to +100 10
0 to 500 300
0 to 500 300
0 to 500 300
0 to 500 300