Kyocera TASKalfa 3050ci Service Manual page 200

Item No.
U411 * : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Method: [DP Auto Adj]
1. Press the start key to output the original for adjustment.
2. Set the output the original for adjustment and press the start key.
3. Set the output the original for adjustment on the DP face up.
4. Press the start key. Auto adjustment of first side starts.
5. Set the output the original for adjustment on the DP face down.
6. Press the start key. Auto adjustment of second side starts.
* : When automatic adjustment has normally completed, [OK] is displayed. If a problem
occurs during auto adjustment, error code is displayed and operation stops. Should this
happen, determine the details of the problem and repeat the procedure from the begin-
ning.
Error Codes
Codes
S001
S002
S003
S004
S005
S006
S007
S008
SFFF
C001
CFFF
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Black band is not detected (main scanning direction far end)
Black band is not detected (main scanning direction near end)
Black band is not detected (auxiliary scanning direction leading edge)
Black band is not detected (auxiliary scanning direction trailing edge)
Auxiliary scanning direction skew 1.5 error
Main scanning direction skew 1.5 error
Original error (detection of reverse original paper)
Original error (page mismatch)
Scanner other error
Controller error
Controller other error
1-3-158
Description
2LK/2LN/2LM/2LC