Adjusting The Print Position Automatically - Kyocera TASKalfa 3050ci Service Manual

Item No.
U415

Adjusting the print position automatically

Description
Automatically adjusts timings at the print engine.
Adjustment for leading edge timing, center line, magnification and margin.
Purpose
Used to make respective auto adjustments for the print engine.
Method
1. Press the start key.
2. Select [Execute].
3. Press the start key. A test pattern is outputted
4. Set the output test pattern as the original.
5. Press the start key. Auto adjustment starts.
6. When normally completed, [OK] is displayed.
If a problem occurs during auto adjustment, error code is displayed.
Error Codes
Codes
S001
S002
S003
S004
S005
S006
S007
S008
SFFF
C101
C102
C103
C104
C105
C106
C107
C108
CFFF
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Black band is not detected (main scanning direction far end)
Black band is not detected (main scanning direction near end)
Black band is not detected (auxiliary scanning direction leading edge)
Black band is not detected (auxiliary scanning direction trailing edge)
Auxiliary scanning direction skew 1.5 error
Main scanning direction skew 1.5 error
Original error (detection of reverse original paper)
Original error (page mismatch)
Scanner other error
Adjustment value error (main scanning direction magnification)
Adjustment value error (auxiliary scanning direction magnification)
Adjustment value error (leading edge timing)
Adjustment value error (center line)
Adjustment value error (B margin)
Adjustment value error (A margin)
Adjustment value error (C margin)
Adjustment value error (D margin)
Controller other error
1-3-161
Description
2LK/2LN/2LM/2LC