Print Position Adjustment (Print Position) - Kyocera TASKalfa Pro 15000c Installation Manual

The main unit setup procedure > Adjustment

(3) Print position adjustment (Print position)

U034 leading edge timing adjustment
1
Get into U034 Adj Paper Timing.
2
Select [Start Position].
• Select [Full (Shift)] for lead edge timing adjustment in full speed.
3
Press [System Menu/Counter] key.
• Set feed cassette or paper speed in Test Print (PG) mode.
• When the optional PF is installed, set the paper feeding source other than MP tray.
4
Press [Start] key to output the adjustment chart.
5
Press [System Menu/Counter] or [Stop] and get back to Full (Shift) screen.
• Select [1st Side] in case of first side adjustment and enter the value. [mm]
• Select [2nd Side] in case of second side adjustment and enter the value. [mm]
6
Change the setting value by using [+] [-] keys or the numeric keys.
• The image moves backward by increasing setting value and moves forward by decreasing the value.
Full(Shift)
1st Side
01
2nd Side
02
Full
1st Side
01
2nd Side
02
Half
1st Side
01
2nd Side
02
• [Full (Shift)]: (Output from cassette, MP tray other than following setting) * With feed accelerating before registration
• [Full]: (Output to MP tray or selecting low paper feed speed) * Without feed accelerating before registration
• [Full (SRA3/12x18)]: * Print Full speed for SRA3/12x18 with duplex only
• [Half]: *Print for 1200dpi or IJ mat paper
One side
or
First side of duplex
U034
-1.50
0.00
U034
-1.50
0.00
U034
-1.50
0.00
Second side of duplex
21.5mm
2-58
[CONFIDENTIAL]