Table of Contents
Advertisement
The Inventory Update Status window (Figure 211) displays status information
about the Inventory Update operation in progress.
Figure 211. Inventory Update Status Window
The Inventory Update Status window contains the following messages:
v Rack XX is being inventoried and Number of racks complete. This display
occurs during the physical inventory operation.
v Database update in progress. This display occurs after the physical inventory
operation.
Note: If the Dual Active Accessors feature is installed, information is displayed for
both accessors (Figure 212).
Figure 212. Inventory Update Status Window (Dual Active Accessor Libraries)
Perform Inventory Update (Partial)
Only those frames associated with doors that have been opened are inventoried. If
Adjacent Frame Update was enabled during the Teach operation, the frames to
either side are also inventoried. If the Dual Active Accessors feature is installed
and if racks on both sides of the 3494 Tape Library are being inventoried, both
accessors are used; otherwise only one accessor is used.
The Perform Inventory Update (Partial) window (Figure 213 on page 330) is used
to select the frames that should be scanned during the Inventory Update operation:
v A selected check box indicates that a frame's door has been opened since the last
inventory.
v A cleared check box indicates that a frame's door has not been opened since the
last inventory.
v The partial Inventory Update operation inventories the frames whose check
boxes are selected.
Chapter 6. Advanced Operating Procedures
329
Advertisement
Table of Contents
